DTC P0791 Intermediate Shaft Speed Sensor "A" Circuit |
DTC P0793 Intermediate Shaft Speed Sensor "A" |

| *1 | Counter Gear | *2 | Clutch Drum |
| *3 | Output Speed Sensor NC | *4 | Input Speed Sensor NT |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0791 | When the speed sensor input voltage is either more than 1.9 V or less than 0.1 V for 2 seconds or more. (1-trip detection logic) |
|
| P0793 | When the vehicle speed is 25 km/h (15.5 mph) or higher, the counter gear speed is less than 300 rpm for 2 seconds or more. (1-trip detection logic) |

| DATA LIST |
Warm up the engine.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
According to the display on the intelligent tester, read the Data List.
| Item | Measurement Item/Range (display) | Normal Condition | Diagnostic Note |
| SPD (NC) | Counter Gear Speed/ display: 50 r/min | - | Data is displayed in increments of 50 rpm |
| 1.INSPECT TRANSMISSION REVOLUTION SENSOR (SPEED SENSOR INSTALLATION) |
Remove the valve body assembly.
![]() |
Make sure that the connector is properly connected, and check the speed sensor installation (Click here).
|
| ||||
| OK | |
| 2.INSPECT TRANSMISSION WIRE |
![]() |
Remove the TCM.
Disconnect the speed sensor connector from the transmission wire.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Condition | Specified Condition |
| 3 (NCO) sensor side - 3 (NCO) TCM side | Always | Below 1 Ω |
| 4 (NCB) sensor side - 4 (NCB) TCM side | Always | Below 1 Ω |
| 3 (NCO) sensor side - Body ground and other terminals | Always | 10 kΩ or higher |
| 4 (NCB) sensor side - Body ground and other terminals | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Wire) |
| *b | TCM side |
| *c | Sensor Side |
|
| ||||
| OK | |
| 3.REPLACE TRANSMISSION REVOLUTION SENSOR |
| NEXT | |
| 4.CHECK IF DTC OUTPUT RECURS (SEE IF DTC P0791 AND/OR P0793 IS OUTPUT AGAIN) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester on.
Clear the DTCs (Click here).
Perform the monitor drive pattern (Click here).
Enter the following menus: Powertrain / ECT / DTC.
Read the DTCs using the intelligent tester.
| Display (DTC Output) | Proceed to |
| Only "P0791 or P0793" is output | A |
| No output | B |
|
| ||||
| A | ||
| ||