DTC P2810 Pressure Control Solenoid "G" Electrical (Shift Solenoid Valve SL4) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2810 | The TCM checks for an open or short in the shift solenoid valve SL4 circuit while driving and shifting gears. (1-trip detection logic)
|
|

| 1.INSPECT TRANSMISSION WIRE (SL4) |
![]() |
Remove the TCM from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 22 (SL4+) - 21 (SL4-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 22 (SL4+) - Body ground and other terminals | Always | 10 kΩ or higher |
| 21 (SL4-) - Body ground and other terminals | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Wire) |
|
| ||||
| OK | ||
| ||
| 2.INSPECT SHIFT SOLENOID VALVE SL4 |
![]() |
Remove shift solenoid valve SL4.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
| *1 | Shift Solenoid Valve SL4 |
Connect a battery positive (+) lead with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating sound.
|
| ||||
| OK | ||
| ||