Home › Drivetrain ยท U660E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > DISASSEMBLY

for Preparation Click here



1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


    C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.



2. REMOVE STATOR SHAFT ASSEMBLY


    C138275
  1. Using a "TORX" socket wrench (T30), remove the 16 bolts and stator shaft assembly from the front oil pump body sub-assembly.

    NOTICE:
    Keep the gears in the order they were removed.



3. INSPECT CLEARANCE OF FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY


    C138509
  1. Push the driven gear to one side of the body.

  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    0.08 to 0.15 mm (0.00315 to 0.00591 in.)

    Maximum clearance:
    0.15 mm (0.00591 in.)

    If the clearance is greater than the maximum, replace the oil pump body sub-assembly.



    C138511
  1. Using a straightedge and feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.025 to 0.04 mm (0.000984 to 0.00157 in.)


    Maximum side clearance:
    0.04 mm (0.00157 in.)
    Drive Gear Thickness 
    Mark
    Thickness
    1
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    2
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    3
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    4
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    5
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)
    Driven Gear Thickness 
    Mark
    Thickness
    1
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    2
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    3
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    4
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    5
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)



4. REMOVE FRONT OIL PUMP BODY O-RING


    C138278
  1. Remove the O-ring from the front oil pump body sub-assembly.



5. REMOVE FRONT OIL PUMP DRIVE GEAR


    C138276
  1. Remove the front oil pump drive gear from the front oil pump body sub-assembly.



6. REMOVE FRONT OIL PUMP DRIVEN GEAR


    C138277
  1. Remove the front oil pump driven gear from the front oil pump body sub-assembly.



7. REMOVE FRONT OIL PUMP OIL SEAL


    C197700E01
  1. Secure the front oil pump body sub-assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using SST, remove the front oil pump oil seal from the front oil pump body sub-assembly.

    SST
    09308-00010