Home › Drivetrain ยท U660E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    C188149E01
  1. Using SST and a hammer, install a new front oil pump oil seal to the front oil pump body sub-assembly.

    SST
    09350-32014   (09351-32140)

    Oil seal driven in depth:
    -0.25 to 0.25 mm (-0.00984 to 0.00984 in.)

  1. Coat the lip of the front oil pump oil seal with MP grease.



2. INSTALL FRONT OIL PUMP BODY O-RING


    C138278
  1. Coat a new O-ring with ATF and install it to the front oil pump body sub-assembly.

    NOTICE:
    Ensure that the O-ring is not twisted.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    C138277
  1. Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly with the marked side facing up.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    C138276
  1. Coat the front oil pump drive gear with ATF, and install it to the front oil pump body sub-assembly with the marked side facing up.



5. INSTALL STATOR SHAFT ASSEMBLY


    C138275E01
  1. Align each knock pin of the stator shaft assembly with the holes in the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly.

  1. Using a "TORX" socket wrench (T30), install the 16 bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

    Bolt Length:
    Bolt A:
    14 mm (0.551 in.)
    Bolt B:
    26 mm (1.02 in.)



6. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


    C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.