Home › Drivetrain ยท U760E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    C138515E01
  1. Coat the lip of a new front oil pump oil seal with a small amount of MP grease.

  1. Using SST and a hammer, install the front oil pump oil seal to the front oil pump body sub-assembly.

    SST
    09350-32014   (09351-32140)

    NOTICE:
    The seal end should be level with the outer edge of the front oil pump body sub-assembly.



2. INSTALL FRONT OIL PUMP BODY O-RING


    C138278
  1. Coat a new front oil pump body O-ring with ATF and install it to the front oil pump body sub-assembly.

    NOTICE:
    Ensure that the O-ring is not twisted.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    C138277
  1. Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly with the marked side up.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    C138276
  1. Coat the front oil pump drive gear with ATF, and install it to the front oil pump body sub-assembly with the marked side up.



5. INSTALL STATOR SHAFT ASSEMBLY


    C138275E01
  1. Align each knock pin of the stator shaft assembly with the holes in the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly with the 16 "TORX" bolts.
    Bolt Length 
    Bolt
    Length [mm (in.)]
    A
    14 (0.551)
    B
    26 (1.02)

  1. Using a T30 "TORX" socket wrench, tighten the 16 "TORX" bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }



6. INSPECT FRONT OIL PUMP ASSEMBLY


    C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.