POWER STEERING SYSTEM > TERMINALS OF ECU |
| CHECK POWER STEERING ECU ASSEMBLY |

| *a | Component without harness connected (Power Steering ECU Assembly) | - | - |
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| j1-1 (IG) - Body ground | R - Body ground | IG power source | Ignition switch ON | 9 to 16 V |
| j1-6 (TS) - Body ground | O - Body ground | Test mode signal | Always | 9 to 16 V |
| j1-7 (CANH) - j1-8 (CANL) | Y - SB | CAN communication line | Ignition switch off | 54 to 69 Ω |
| z16-1 (TRQ2) - Body ground | Y - Body ground | Torque sensor signal | Engine running Steering wheel not being turned (without load) | 2.3 to 2.7 V |
| Engine running Steering wheel being turned to right with vehicle stopped | 1.2 to 2.5 V | |||
| Engine running Steering wheel being turned to left with vehicle stopped | 2.5 to 3.8 V | |||
| z16-2 (TRQG) - Body ground | B - Body ground | Torque sensor ground | Always | Below 1 Ω |
| z16-8 (TRQV) - Body ground | R - Body ground | Torque sensor voltage source | Engine running | 4.5 to 5.5 V |
| z16-9 (TRQ1) - Body ground | W - Body ground | Torque sensor signal | Engine running Steering wheel not being turned (without load) | 2.3 to 2.7 V |
| Engine running Steering wheel being turned to right with vehicle stopped | 2.5 to 3.8 V | |||
| Engine running Steering wheel being turned to left with vehicle stopped | 1.2 to 2.5 V | |||
| j2-1 (PIG) - Body ground | R - Body ground | Power source | Always | 9 to 16 V |
| j2-2 (PGND) - Body ground | B - Body ground | Power ground | Always | Below 1 Ω |