Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the intelligent tester on.

  5. Enter the following menus: Chassis / EMPS / Data List.

  6. According to the display on the intelligent tester, read the Data List.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Meter Vehicle Velocity
    Vehicle speed from meter/
    Min.: 0.0 km/h (0.0 mph)
    Max.: 300.0 km/h (186.4 mph)
    0 km/h (0 mph)
    Engine running and vehicle stopped
    No significant fluctuation
    Engine running and vehicle driven at a constant speed
    Wheel Speed Right
    Rear right wheel speed/
    Min.: 0 km/h (0 mph)
    Max.: 255 km/h (158 mph)
    0 km/h (0 mph)
    Engine running and vehicle stopped
    No significant fluctuation
    Engine running and vehicle driven at a constant speed
    Wheel Speed Left
    Rear left wheel speed/
    Min.: 0 km/h (0 mph)
    Max.: 255 km/h (158 mph)
    0 km/h (0 mph)
    Engine running and vehicle stopped
    No significant fluctuation
    Engine running and vehicle driven at a constant speed
    Engine Revolution
    Engine speed/
    Min.: 0 rpm
    Max.: 12800 rpm
    No significant fluctuation
    Engine running at a constant speed
    Motor Actual Current*1
    Amount of current to motor/
    Min.: -327.68 A
    Max.: 327.67 A
    Value changes in proportion to steering effort
    - The value increases when turning right and decreases when turning left
    Engine running and steering wheel being turned
    Motor Actual Current*2
    Amount of current to motor/
    Min.: -327.68 A
    Max.: 327.67 A
    Value changes in proportion to steering effort
    - The value increases when turning left and decreases when turning right
    Engine running and steering wheel being turned
    Command Value Current*1
    Requested current to motor/
    Min.: -327.68 A
    Max.: 327.67 A
    Value changes in proportion to steering effort
    - The value increases when turning right and decreases when turning left
    Engine running and steering wheel being turned
    Command Value Current*2
    Requested current to motor/
    Min.: -327.68 A
    Max.: 327.67 A
    Value changes in proportion to steering effort
    - The value increases when turning left and decreases when turning right
    Engine running and steering wheel being turned
    Steering Angle Velocity
    Steering angle speed/
    Min.: -32768 deg/s
    Max.: 32767 deg/s
    Value changes in proportion to steering speed
    - The value increases when turning left and decreases when turning right
    Engine running and steering wheel being turned
    Thermistor Temperature
    ECU substrate temperature/
    Min.: -50.0°C (-58.0°F)
    Max.: 150.0°C (302.0°F)
    -50°C to 150°C (-58°F to 302°F)
    -
    PIG Power Supply
    Power source voltage to active motor/
    Min.: 0.0000 V
    Max.: 20.1531 V
    9 to 16 V
    Always
    IG Power Supply
    IG power source voltage/
    Min.: 0.0000 V
    Max.: 20.1531 V
    9 to 16 V
    Ignition switch ON
    Steering Angle Sens Sig
    Steering angle sensor signal state/
    OK or NG(1) or NG(2) or NG(3)
    OK: Steering angle sensor signal received
    NG(1): The learning has not completed
    NG(2): Steering Sensor Abnormal
    NG(3): Communication Error
    -
    Steering Wheel Torque
    Steering wheel torque/
    Min.: -327.68 Nm
    Max.: 7.00 Nm
    Value changes in proportion to steering effort
    - The value increases when turning left and decreases when turning right
    Engine running and steering wheel being turned
    Motor Rotation Angle
    Motor rotation angle/
    Min.: 0.000 deg
    Max.: 1441.770 deg
    During steering operation, motor rotation angle value changes from 0 to 360°
    Engine running and steering wheel being turned
    Command Val Current 2*1
    Requested current to motor/
    Min.: -327.68 A
    Max.: 327.67 A
    Value changes in proportion to steering effort
    - The value increases when turning left and decreases when turning right
    Engine running and steering wheel being turned
    Command Val Current 2*2
    Requested current to motor/
    Min.: -327.68 A
    Max.: 327.67 A
    Value changes in proportion to steering effort
    - The value increases when turning right and decreases when turning left
    Engine running and steering wheel being turned
    Motor Voltage
    Motor power supply voltage/
    Min.: 0.000 V
    Max.: 98.000 V
    9 to 16 V
    Always
    Motor Terminal Volt (U)
    Motor terminal voltage (U phase)/
    Min.: 0.000 V
    Max.: 98.000 V
    Value changes within 4 to 16 V range
    Engine running and steering wheel being turned
    Motor Terminal Volt (V)
    Motor terminal voltage (V phase)/
    Min.: 0.000 V
    Max.: 98.000 V
    Value changes within 4 to 16 V range
    Engine running and steering wheel being turned
    Motor Terminal Volt (W)
    Motor terminal voltage (W phase)/
    Min.: 0.000 V
    Max.: 98.000 V
    Value changes within 4 to 16 V range
    Engine running and steering wheel being turned
    Torque Sensor 1 Output
    Torque sensor voltage/
    Min.: 0.0000 V
    Max.: 4.9725 V
    2.3 to 2.7 V
    Engine running and steering wheel not being turned (without load)
    2.5 to 3.8 V
    Engine running and steering wheel being turned to the right with vehicle stopped
    1.2 to 2.5 V
    Engine running and steering wheel being turned to the left with vehicle stopped
    Torque Sensor 2 Output
    Torque sensor voltage/
    Min.: 0.0000 V
    Max.: 4.9725 V
    2.3 to 2.7 V
    Engine running and steering wheel not being turned (without load)
    1.2 to 2.5 V
    Engine running and steering wheel being turned to the right with vehicle stopped
    2.5 to 3.8 V
    Engine running and steering wheel being turned to the left with vehicle stopped
    TRQ1 Zero Point Value
    Torque sensor voltage/
    Min.: 0.0000 V
    Max.: 4.9725 V
    Values differ depending on vehicle
    Engine running and steering wheel not being turned
    TRQ2 Zero Point Value
    Torque sensor voltage/
    Min.: 0.0000 V
    Max.: 4.9725 V
    Values differ depending on vehicle
    Engine running and steering wheel not being turned
    IG ON/OFF Times
    Number of times of ignition switch ON/OFF after fail detection/
    Min.: 0 times
    Max.: 65535 times
    -
    This value indicates the number of times of ignition switch ON/OFF after the latest DTC detection.
    Motor Overheat Record
    Continuous overheat prevention control record/
    Unrec or Rec
    Unrec
    Unrec: Unrecorded
    Rec: Recorded
    Motor Lo Power Record
    PIG power source voltage drop record/
    Unrec or Rec
    Unrec
    Unrec: Unrecorded
    Rec: Recorded
    Eng Rev Inter Record
    Record of READY ON signal interruption/
    Unrec or Rec
    Unrec
    Unrec: Unrecorded
    Rec: Recorded
    Str Angle Inter Record
    Record of steering sensor signal interruption occurrence display/
    Unrec or Rec
    Unrec
    Unrec: Unrecorded
    Rec: Recorded
    Spd Sig Invalid Record
    Record of vehicle speed signal invalid/
    Unrec or Rec
    Unrec
    Unrec: Unrecorded
    Rec: Recorded
    Battery Voltage Lo Record
    Battery voltage reduction history/
    Min.: 0 times, Max.: 65535 times
    0 to 65535
    -
    PS Assist Signal
    Status of the Record of Power Steering Assist Signal/
    OFF or ON
    OFF
    Ignition switch ON
    ON
    Engine running
    Motor Overheat Limit Cnt(Normal)
    Number of times that assist limit was performed according to the estimated temperature of the portion where heat was generated in the power steering ECU assembly and motor coil/
    Min.: 0 times
    Max.: 255 times
    -
    -
    Assist Limit Cnt(Power Voltage Low)
    Number of times that assist limit was performed due to battery voltage having dropped to 9 V or below/
    Min.: 0 times
    Max.: 255 times
    -
    -
    Power Vol Low Prevention Limit Cnt
    Number of times that assist limit was performed due to battery voltage having dropped to 9.7 V or below/
    Min.: 0 times
    Max.: 255 times
    -
    -
    Eng Stall/Ready OFF Cnt
    Number of times that assist limit was performed after the engine stalled and the ignition switch was turned off
    Min.: 0 times
    Max.: 255 times
    -
    -
    Motor Overheat Limit Cnt(Motor Overload)
    Number of times that assist limit was performed to prevent the system from overheating in a case where the motor is overloaded because it is locked due to the steering wheel being turned to the full lock position or a tire hitting a curb/
    Min.: 0 times
    Max.: 255 times
    -
    -
    DCDC Current Limit Cnt(DCDC Malf)
    Number of times that the power steering ECU has limited the current to the power steering motor while the DC/DC converter is malfunctioning/
    Min.: 0 times
    Max.: 255 times
    -
    -
    Assist Limit Cnt(Vehicle Spd Sig Malf)
    Number of times that assist power was set to a value suitable for highspeed driving when high speed is detected due to an abnormal vehicle speed signal/
    Min.: 0 times
    Max.: 255 times
    -
    -
    Battery Voltage Keep Limit Cnt
    Number of times that the system was limited to conserve battery voltage/
    Min.: 0 times
    Max.: 255 times
    -
    -
    Assist Limit Record 1
    Information of assist limit that was used in the past or is currently in use (latest history)/
    Unrec, Mtr Overheat, Pow Vol Low, Pow Vol Low Prevent, Eng Stall, Ready OFF, Mtr Overload, Vhcl Spd Sig Malf, Batt Vol Keep
    -
    -
    Record 1 Key Cycle
    Number of times that the ignition switch was turned ON before Assist Limit Record 1 was stored/
    Min.: 0 times
    Max.: 65535 times
    -
    -
    Record 1 Key Cycle Elapsed Time
    Period of time that elapsed since the ignition switch was turned ON before Assist Limit Record 1 was stored/
    Min.: 0.0 s
    Max.: 53687091.1 s
    -
    -
    Assist Limit Record 2
    Information of assist limit that was used in the past (second latest history)/
    Unrec, Mtr Overheat, Pow Vol Low, Pow Vol Low Prevent, Eng Stall, Ready OFF, Mtr Overload, Vhcl Spd Sig Malf, Batt Vol Keep
    -
    -
    Record 2 Key Cycle
    Number of times that the ignition switch was turned ON after Assist Limit Record 2 was stored before Assist Limit Record 1 was stored/
    Min.: 0 times
    Max.: 65535 times
    -
    -
    Record 2 Key Cycle Elapsed Time
    Period of time that elapsed since the ignition switch was turned ON before Assist Limit Record 2 was stored/
    Min.: 0.0 s
    Max.: 53687091.1 s
    -
    -
    Assist Limit Record 3
    Information of assist limit that was used in the past (third latest history)/
    Unrec, Mtr Overheat, Pow Vol Low, Pow Vol Low Prevent, Eng Stall, Ready OFF, Mtr Overload, Vhcl Spd Sig Malf, Batt Vol Keep
    -
    -
    Record 3 Key Cycl
    Number of times that the ignition switch was turned ON after Assist Limit Record 3 was stored before Assist Limit Record 2 was stored/
    Min.: 0 times
    Max.: 65535 times
    -
    -
    Record 3 Key Cycle Elapsed Time
    Period of time that elapsed since the ignition switch was turned ON before Assist Limit Record 3 was stored/
    Min.: 0.0 s
    Max.: 53687091.1 s
    -
    -
    Current Key Cycle
    Number of times that ignition switch was turned ON/
    Min.: 0 times
    Max.: 65535 times
    -
    -
    Current Key Cycle Elapsed Time
    Time elapsed since ignition switch was turned ON/
    Min.: 0.0 s
    Max.: 53687091.1 s
    -
    -
    The Number of DTCs
    Number of detected DTCs when freeze frame data stored/
    Min.: 0
    Max.: 255
    0 to 255
    -

HINT:
  1. *1: for LHD
  2. *2: for RHD