DIFFERENTIAL CASE > INSPECTION |
| 1. INSPECT FRONT DIFFERENTIAL CASE |
![]() |
Using SST, rotate the front differential side gear as shown in the illustration.
| 2. INSPECT FRONT DIFFERENTIAL SIDE GEAR THRUST AMOUNT |
![]() |
Using SST and a dial indicator, measure the front differential side gear thrust amount.
| *a | Front Differential Side Gear Thrust Amount |
| 3. INSPECT FRONT DIFFERENTIAL PINION BACKLASH |
Install SST as shown in the illustration and tighten it.

| *a | Turn | *b | Hold |
Secure the front differential case in a vise between aluminum plates.
![]() |
Install the front No. 1 differential pinion shaft to the front differential pinion as shown in the illustration.
| *1 | Front No. 1 Differential Pinion Shaft |
Using a dial indicator, measure the front differential pinion backlash.
| Part No. | Thickness (mm (in.)) |
| 41361-33020 | 1.50 (0.0591) |
| 41361-33030 | 1.55 (0.0610) |
| 41361-33040 | 1.60 (0.0630) |
| 41361-33050 | 1.65 (0.0650) |
| 41361-33060 | 1.70 (0.0669) |
| 41361-33070 | 1.75 (0.0689) |
| 41361-33080 | 1.80 (0.0709) |
| 41361-33090 | 1.85 (0.0728) |
| 41361-33100 | 1.90 (0.0748) |
| 4. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER |
![]() |
Using a micrometer, measure the thickness of the front differential pinion thrust washer.
| 5. INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.