DIFFERENTIAL CASE > INSPECTION |
| 1. INSPECT FRONT DIFFERENTIAL CASE |
![]() |
Using SST, rotate the front differential side gear as shown in the illustration.
| 2. INSPECT FRONT DIFFERENTIAL PINION BACKLASH |
Install SST as shown in the illustration and tighten it.

| *a | Turn | *b | Hold |
Secure the front differential case with front differential ring gear in a vise between aluminum plates.
![]() |
Install the front No. 1 differential pinion shaft to the front differential pinion as shown in the illustration.
| *1 | Front No. 1 Differential Pinion Shaft |
Using a dial indicator, measure the front differential pinion backlash.
| Part No. | Thickness (mm (in.)) |
| 41361-73050 | 0.90 (0.0354) |
| 41361-73010 | 1.00 (0.0394) |
| 41361-73020 | 1.10 (0.0433) |
| 41361-73030 | 1.20 (0.0472) |
| 3. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER |
![]() |
Using a micrometer, measure the thickness of the front differential pinion thrust washer.
| 4. INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.