DIFFERENTIAL CASE > DISASSEMBLY |
| 1. REMOVE FRONT TRANSAXLE CASE OIL SEAL |
![]() |
Using SST and a hammer, remove the front transaxle case oil seal from the transaxle housing.
| 2. REMOVE TRANSAXLE CASE OIL SEAL |
![]() |
Using SST and a hammer, remove the transaxle case oil seal from the transaxle case sub-assembly.
| 3. INSPECT FRONT DIFFERENTIAL CASE |
![]() |
Using SST, rotate the front differential side gear as shown in the illustration.
| 4. REMOVE FRONT DIFFERENTIAL RING GEAR |
![]() |
Put matchmarks on the front differential ring gear and front differential case.
| *a | Matchmark |
![]() |
Remove the 12 bolts from the front differential ring gear.
![]() |
Using a plastic hammer, tap on the front differential ring gear to remove it from the front differential case.
| 5. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
Secure the front differential case in a vise between aluminum plates.
![]() |
Using a 5 mm pin punch and a hammer, remove the front differential pinion shaft straight pin from the front differential case.
| 6. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Remove the front No. 1 differential pinion shaft from the front differential case.
| 7. INSPECT FRONT DIFFERENTIAL PINION BACKLASH |
Install SST as shown in the illustration and tighten it.

| *a | Turn | *b | Hold |
Secure the front differential case in a vise between aluminum plates.
![]() |
Install the front No. 1 differential pinion shaft to the front differential pinion as shown in the illustration.
| *1 | Front No. 1 Differential Pinion Shaft |
Using a dial indicator, measure the front differential pinion backlash.
| Part No. | Thickness (mm (in.)) |
| 41361-73050 | 0.90 (0.0354) |
| 41361-73010 | 1.00 (0.0394) |
| 41361-73020 | 1.10 (0.0433) |
| 41361-73030 | 1.20 (0.0472) |
| 8. REMOVE FRONT DIFFERENTIAL SIDE GEAR |
Install SST as shown in the illustration and tighten it.

| *a | Turn | *b | Hold |
![]() |
Install SST as shown in the illustration, rotate the front differential side gear, and then remove the 2 front differential pinions and 2 front differential pinion thrust washers from the front differential case.
| *a | Turn |
![]() |
Remove SST from the front differential case, and then remove the 2 front differential side gears, 2 front No. 1 differential side gear thrust washers and 2 conical springs from the front differential case.
| *1 | Front Differential Side Gear |
| *2 | Conical Spring |
| *3 | Front No. 1 Differential Side Gear Thrust Washer |
| 9. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case front tapered roller bearing (inner race) from the front differential case.
| *a | Turn |
| *b | Hold |
![]() |
Using SST, remove the front differential case front tapered roller bearing (outer race) and shim from the transaxle housing.
| 10. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case rear tapered roller bearing (inner race) from the front differential case.
| *a | Turn |
| *b | Hold |
![]() |
Using SST, remove the front differential case rear tapered roller bearing (outer race) from the transaxle case sub-assembly.