Home › Drivetrain · U660E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT SHIFT SOLENOID VALVE SL


    C188295E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Solenoid Connector (SL) - Solenoid Body (SL)
    20°C (68°F)
    11 to 15 Ω

    Text in Illustration 
    *a
    Shift Solenoid Valve SL
    If the value is not as specified, replace the shift solenoid valve.

  1. Connect a positive (+) lead from the battery to the terminal of the solenoid connector, and a negative (-) lead to the solenoid body, and check the operation of the valve.

    NOTICE:
    When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

    OK:
    The valve moves and makes an operating sound.

    If the operation cannot be done as specified, replace the shift solenoid valve.



2. INSPECT SHIFT SOLENOID VALVE (SLT, SLU, SL1, SL2, SL3, SL4)


    C158063E26
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    5.0 to 5.6 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Shift Solenoid Valve SLT, SLU, SL1, SL2, SL3, SL4)
    If the value is not as specified, replace the shift solenoid valve.

  1. Connect a positive (+) lead from the battery with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector, and check the operation of the valve.

    NOTICE:
    When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

    OK:
    The valve moves and makes an operating sound.

    If the operation cannot be done as specified, replace the shift solenoid valve.