VALVE BODY ASSEMBLY > INSPECTION |
| 1. INSPECT SHIFT SOLENOID VALVE SL |
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Shift Solenoid Valve SL) |
| Tester Connection | Condition | Specified Condition |
| Solenoid Connector - Solenoid Body | 20°C (68°F) | 11 to 15 Ω |
Connect a battery positive (+) lead to the terminal of the solenoid valve connector, and a negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating sound.
| 2. INSPECT SHIFT SOLENOID VALVE SLT |
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Shift Solenoid Valve SLT) |
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Connect a battery positive (+) lead with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating sound.
| 3. INSPECT SHIFT SOLENOID VALVE SLU |
| 4. INSPECT SHIFT SOLENOID VALVE SL1 |
| 5. INSPECT SHIFT SOLENOID VALVE SL2 |
| 6. INSPECT SHIFT SOLENOID VALVE SL3 |
| 7. INSPECT SHIFT SOLENOID VALVE SL4 |