Home › Drivetrain · U761E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT SHIFT SOLENOID VALVE SL


    C188295E03
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Shift Solenoid Valve SL)
    Standard Resistance 
    Tester Connection
    Condition
    Specified Condition
    Solenoid Connector - Solenoid Body
    20°C (68°F)
    11 to 15 Ω

    1. If the result is not as specified, replace the shift solenoid valve SL.

  1. Connect a positive (+) lead from the battery to the terminal of the shift solenoid valve SL connector and a negative (-) lead to the shift solenoid valve SL body, and check the operation of the valve.

    NOTICE:
    When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

    OK:
    The valve moves and makes an operating sound.

    1. If the result is not as specified, replace the shift solenoid valve SL.



2. INSPECT SHIFT SOLENOID VALVE SLT


    C201747E25
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Shift Solenoid Valve SLT)
    *b
    21 W Bulb
    Standard Resistance 
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    5.0 to 5.6 Ω
    If the result is not as specified, replace the shift solenoid valve SLT.

  1. Connect a positive (+) lead with a 21 W bulb from the battery to terminal 2 and a negative (-) lead to terminal 1 of the shift solenoid valve SLT connector and check the operation of the valve.

    NOTICE:
    When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

    OK:
    The valve moves and makes an operating sound.

    If the result is not as specified, replace the shift solenoid valve SLT.



3. INSPECT SHIFT SOLENOID VALVE SLU

HINT:
Use the same procedure as for the shift solenoid valve SLT.



4. INSPECT SHIFT SOLENOID VALVE SL1

HINT:
Use the same procedure as for the shift solenoid valve SLT.



5. INSPECT SHIFT SOLENOID VALVE SL2

HINT:
Use the same procedure as for the shift solenoid valve SLT.



6. INSPECT SHIFT SOLENOID VALVE SL3

HINT:
Use the same procedure as for the shift solenoid valve SLT.



7. INSPECT SHIFT SOLENOID VALVE SL4

HINT:
Use the same procedure as for the shift solenoid valve SLT.