INTAKE SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT INTAKE SYSTEM |
Check that there are no vacuum leaks at the points shown in the illustration.


| 2. INSPECT INTAKE AIR CONTROL VALVE (for ACIS) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester on.
Warm up the engine.
![]() |
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Intake Control.
When "Activate the VSV for Intake Control" is turned on, check that the actuator rod operates.
If the operation is not as specified, inspect the intake air control valve, vacuum tank and check valve (Click here).
When "Activate the VSV for Intake Control" is turned off, check that the actuator rod returns to its original position.
If the operation is not as specified, inspect the intake air control valve and vacuum hose (Click here).
| 3. INSPECT INTAKE AIR CONTROL VALVE ACTUATOR (for TCV) (w/ TCV) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / All Data / Control the IAC Duty Ratio.
Set the duty ratio to 60% or -60% for 1 to 3 seconds, and then return the duty ratio to 0%. Check Intake Air Control Position in the Data List.
| Condition (Active Test) | Specified Condition (Data List) |
| Control the IAC Duty Ratio set to 60% | Intake Air Control Position 35° or more |
| Control the IAC Duty Ratio set to -60% | Intake Air Control Position 17° or less |
| Condition (Active Test) | Specified Condition (Data List) |
| Control the IAC Duty Ratio set to 100% | Intake Air Control Position 70° or more |
| Control the IAC Duty Ratio set to -100% | Intake Air Control Position 2° or less |
When the result is not as specified during the Active Test, perform the following procedure.
![]() |
Remove the intake manifold (Click here).
| *a | Condition: Closed |
| *b | Condition: Open |
Check that the valves move when connecting the battery to the terminals of the intake air control valve actuator.
| Tester Connection | Specified Condition |
| Positive (+) battery voltage applied to terminal 4 (M-), and negative (-) battery voltage applied to terminal 5 (M+) | Open → Closed |
| Positive (+) battery voltage applied to terminal 5 (M+), and negative (-) battery voltage applied to terminal 4 (M-) | Closed → Open |
![]() ![]() |
When the results are not as specified, perform the following inspections.
Check that the valves are not cracked or deformed.
Remove the intake air control actuator (Click here), and check that the valves move smoothly.
If there are no problems with the valves, inspect the intake air control valve actuator (Click here).