Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 2GR-FE)

COMPRESSOR (for 2GR-FE) > INSPECTION

for Preparation Click here



1. INSPECT COMPRESSOR AND MAGNET CLUTCH (A/C LOCK SENSOR)


    E167398E42
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E73-1 (SSR+)- E73-2 (SSR-)
    20°C (68°F)
    160 to 320 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Compressor and Magnet Clutch (A/C Lock Sensor))
    If the resistance is not as specified, replace the compressor and magnet clutch.



2. INSPECT COMPRESSOR AND MAGNET CLUTCH (COMPRESSOR SOLENOID)


    E229635E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-1 (SOL-) - E74-2 (SOL+)
    20°C (68°F)
    10 to 11 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Compressor and Magnet Clutch (Compressor Solenoid))
    If the resistance is not as specified, replace the compressor and magnet clutch.



3. INSPECT COMPRESSOR AND MAGNET CLUTCH
  1. Disconnect the E73 compressor and magnet clutch connector.



    E228787E03
  1. Disconnect the a2 magnetic clutch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E73-3 (MG+) - a2-1
    Always
    Below 1 Ω
    E73-3 (MG+) - Body ground
    Always
    10 kΩ or higher

    If the resistance is not as specified, replace the compressor and magnet clutch.
    Text in Illustration 
    *a
    Component without harness connected
    (Compressor and Magnet Clutch)
    *b
    Component without harness connected
    (Magnetic Clutch Assembly)