Home › Drivetrain ยท U761E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE
  1. Install the transmission wire and lock plate to the transmission valve body assembly with the bolt.

    Torque:
    10.8 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Coat the temperature sensor with ATF.

  1. Connect the temperature sensor and install the lock plate with the bolt to the transmission valve body assembly.

    Torque:
    10.8 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Engage the clamp.

  1. Connect the 7 shift solenoid valve connectors.

  1. Connect the transmission revolution sensor connector.



2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY
(Click here)