Home › Drivetrain · U660E AUTOMATIC TRANSMISSION / TRANSAXLE › ATF TEMPERATURE SENSOR

ATF TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ATF TEMPERATURE SENSOR ASSEMBLY


    C133224E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    THO1 - E2
    10°C (50°F)
    5 to 8 kΩ
    THO1 - E2
    25°C (77°F)
    2.5 to 4.5 kΩ
    THO1 - E2
    110°C (230°F)
    0.22 to 0.28 kΩ
    THO1 - Body ground
    Always
    10 kΩ or higher

    If the resistance is out of the specified range with the ATF temperature shown in the preceding table, replace the ATF temperature sensor assembly. Otherwise, the driveability of the vehicle may decrease.