Home › General › SPECIFICATIONS › 6AR-FSE STARTING

6AR-FSE STARTING > SERVICE DATA



Starter assembly
Standard current: 90 A or less at 11.5 V
Repair service starter kit
Standard resistance
50 - C: Below 1 Ω
50 - Body: Below 2 Ω
Starter armature assembly
Standard resistance
Segment - Segment: Below 1 Ω
Segment - Starter armature core: 10 kΩ or higher
Standard length: 3.1 to 3.8 mm (0.122 to 0.149 in.)
Maximum length: 3.8 mm (0.149 in.)
Starter commutator end frame
Standard length: 9.0 mm (0.354 in.)
Minimum length: 4.0 mm (0.157 in.)
Standard resistance
Positive (+) brush - Negative (-) brush: 10 kΩ or higher
Snap ring
Maximum length: 5.0 mm (0.196 in.)
Starter relay
3 - 5: 10 kΩ or higher (when battery voltage not applied between terminals 1 and 2)
3 - 5: Below 1 Ω (when battery voltage applied between terminals 1 and 2)
Engine switch
5 (SS1) - 6 (GND) / 1 (SS2) - 6 (GND)
Specified resistance
Not pushed: 10kΩ or higher
Pushed: Below 1 Ω
Standard condition: Illuminates
Measurement condition
Battery positive (+) → Terminal 9 (SWIL) Battery negative (-) → Terminal 6 (GND)