Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM

DTC    B124B    Automatic High Beam System

for Preparation Click here


DESCRIPTION

This DTC is stored when the main body ECU (multiplex network body ECU) detects a malfunction in the automatic high beam system.

DTC No.
DTC Detection Condition
Trouble Area
B124B
Malfunction in automatic high beam system
  1. Vehicle stability control system
  2. CAN communication system
  3. Inner rear view mirror assembly
  4. Main body ECU (multiplex network body ECU)

INSPECTION PROCEDURE

NOTICE:
Confirm that the CAN communication system is not malfunctioning before performing the following inspection (Click here).

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B124B is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    Result:

    Result
    Proceed to
    Other DTCs are not output
    A
    Vehicle stability control system DTCs are output
    B
    CAN communication system DTCs are output
    C



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


3.REPLACE INNER REAR VIEW MIRROR ASSEMBLY
  1. Replace the inner rear view mirror assembly with a new or known good one (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B124B is not output.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (INNER REAR VIEW MIRROR ASSEMBLY WAS DEFECTIVE)