DOOR CONTROL TRANSMITTER (w/ Smart Entry and Start System) > INSTALLATION |
| 1. INSTALL TRANSMITTER BATTERY |
for Type A:
![]() |
Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward, as shown in the illustration.
![]() |
Install the transmitter housing cover by pressing down on it as shown in the illustration.
![]() |
Insert the mechanical key into the transmitter.
Press one of the transmitter switches and check that the LED illuminates.
for Type B:
![]() |
Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward, as shown in the illustration.
![]() |
Engage the 2 claws and install the cover.
![]() |
Install the transmitter housing cover by pressing down on it as shown in the illustration.
![]() |
Insert the mechanical key into the transmitter.
Press one of the transmitter switches and check that the LED illuminates.
for Type C:
![]() |
Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward, as shown in the illustration.
![]() |
Install the transmitter housing cover by pressing down on it as shown in the illustration
![]() |
Insert the mechanical key into the transmitter.
Press one of the transmitter switches and check that the LED illuminates.