DTC U0200 Lost Communication with "Door Control Module B" |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0200 | No communication from the outer mirror control ECU assembly continues. |
|

| 1.RECONFIRM DTC OUTPUT |
Reconfirm DTCs.
| Result | Proceed to |
| DTC U1002 is not output from main body ECU (multiplex network body ECU) (GTS display: Main Body) | A |
| DTC U1002 is output from main body ECU (multiplex network body ECU) (GTS display: Main Body) | B |
|
| ||||
| A | |
| 2.CHECK FOR OPEN IN SUB BUS 1 LINES (OUTER MIRROR CONTROL ECU ASSEMBLY (FOR DRIVER SIDE) BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the K12 outer mirror control ECU assembly (for driver side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K12-9 (CANP) - K12-8 (CANN) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Outer Mirror Control ECU Assembly (for Driver Side)) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K12-7 (GND) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
| *a | Front view of wire harness connector (to Outer Mirror Control ECU Assembly (for Driver Side)) |
Reconnect the cable to the negative (-) battery terminal.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K12-5 (SIG) - Body ground | Ignition switch ON | 11 to 14 V |
| K12-6 (CPUB) - Body ground | Ignition switch off | 11 to 14 V |
| *a | Front view of wire harness connector (to Outer Mirror Control ECU Assembly (for Driver Side)) |
|
| ||||
| OK | ||
| ||