Home › Vehicle Exterior › LIGHTING (EXT) › AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)

DTC    B2410    Headlight Swivel Motor LH Communication Malfunction

DTC    B2411    Headlight Swivel Motor RH Communication Malfunction

for Preparation Click here


DESCRIPTION

These DTCs are stored when the AFS ECU (headlight swivel ECU assembly) detects errors in its own communication with the headlight swivel motor.

DTC No.
DTC Detection Condition
Trouble Area
B2410
AFS ECU (headlight swivel ECU assembly) detected errors in its own communication with headlight swivel motor LH
  1. Headlight swivel motor LH
  2. Harness or connector
  3. AFS ECU (headlight swivel ECU assembly)
B2411
AFS ECU (headlight swivel ECU assembly) detected errors in its own communication with headlight swivel motor RH
  1. Headlight swivel motor RH
  2. Harness or connector
  3. AFS ECU (headlight swivel ECU assembly)

WIRING DIAGRAM


E197126E03


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2410 or B2411 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (BATTERY - AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY))


    E166980E39
  1. Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A35-14 (IGS) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to AFS ECU (Headlight Swivel ECU Assembly))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - BODY GROUND)


    E166980E40
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A35-22 (E1) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to AFS ECU (Headlight Swivel ECU Assembly))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - HEADLIGHT UNIT)
  1. Disconnect the LH side or RH side headlight unit connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    LH Side (B2410) 
    Tester Connection
    Condition
    Specified Condition
    A35-1 (SMBL) - A22-1 (SMBL)
    Always
    Below 1 Ω
    A35-29 (SML) - A22-2 (SML)
    Always
    Below 1 Ω
    A35-23 (SMGL) - A22-3 (SMGL)
    Always
    Below 1 Ω
    A35-1 (SMBL) - Body ground
    Always
    10 kΩ or higher
    A35-29 (SML) - Body ground
    Always
    10 kΩ or higher
    A35-23 (SMGL) - Body ground
    Always
    10 kΩ or higher
    RH Side (B2411) 
    Tester Connection
    Condition
    Specified Condition
    A35-2 (SMBR) - A67-1 (SMBR)
    Always
    Below 1 Ω
    A35-10 (SMR) - A67-2 (SMR)
    Always
    Below 1 Ω
    A35-24 (SMGR) - A67-3 (SMGR)
    Always
    Below 1 Ω
    A35-2 (SMBR) - Body ground
    Always
    10 kΩ or higher
    A35-10 (SMR) - Body ground
    Always
    10 kΩ or higher
    A35-24 (SMGR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)


    E166987E13
  1. Reconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    LH Side (B2410) 
    Tester Connection
    Condition
    Specified Condition
    A35-1 (SMBL) - A35-23 (SMGL)
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    RH Side (B2411) 
    Tester Connection
    Condition
    Specified Condition
    A35-2 (SMBR) - A35-24 (SMGR)
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Component with harness connected
    (AFS ECU (Headlight Swivel ECU Assembly))



NG
REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) (Click here)
OK


6.CHECK HEADLIGHT UNIT (HEADLIGHT SWIVEL MOTOR)
  1. Replace the headlight unit with a new or a known good one (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2410 or B2411 is not output.



NG
REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) (Click here)
OK

END (HEADLIGHT SWIVEL MOTOR WAS DEFECTIVE)