Component
| Function
|
Front power seat switch LH (w/ Memory)
| Based on the switch operation, seat adjuster signals are input to the front power seat switch LH (w/ Memory) to adjust the seat accordingly.
|
Separate type front seat cushion assembly
| Slide motor
| Receives a signal from the front power seat switch LH (w/ Memory), and slides the seat forward and rearward.
|
Front vertical motor
| Receives a signal from the front power seat switch LH (w/ Memory), and raises and lowers the front of the seat cushion.
|
Lifter motor
| Receives a signal from the front power seat switch LH (w/ Memory), and raises and lowers the seat cushion.
|
Position sensor
| Built into each motor and sends position data to the front power seat switch LH (w/ Memory) so that it can detect the position at all times.
|
Separate type front seatback assembly
| Reclining motor
| Receives a signal from the front power seat switch LH (w/ Memory), and tilts the seatback forward and rearward.
|
Position sensor
| Built into the reclining motor and sends position data to the front power seat switch LH (w/ Memory) so that the ECU can detect the position at all times.
|
Lumbar support adjuster assembly
| Receives a signal from the lumbar front power seat switch and operates the built-in motor to adjust the lumbar support.
|
Seat memory switch
| If the seat memory SET switch is being pressed when one of the M1 or M2 seat memory switches is pressed, or if one of the M1 or M2 switches is pressed within 3 seconds of pressing the SET switch, the outer mirror control ECU assembly LH sends the signals so that the seat position can be stored. Then, when a seat memory switch is pressed, a signal is sent to the outer mirror control ECU assembly LH and the seat position changes according to memory.
|
Lumbar front power seat switch
| Operates the motor built into lumbar support adjuster assembly according to switch operation.
|