Home › Engine / Hybrid System ยท 2GR-FE › INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


2. REMOVE ENGINE UNDER COVER RH


3. REMOVE RADIATOR RESERVE TANK ASSEMBLY


    A255301
  1. Disconnect the radiator reserve tank hose.

  1. Remove the 2 bolts and radiator reserve tank assembly.



4. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Front Side)


    A255354
  1. Remove the 2 nuts and No. 1 exhaust pipe support bracket (for Front Side).



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A255349
  1. Disconnect the 2 wire harnesses from the clamp.

  1. Disconnect the 2 heated oxygen sensor connectors.



    A255350
  1. Remove the 2 bolts and No. 1 exhaust pipe support bracket (for Rear Side).



    A255351
  1. Remove the 4 bolts, 4 nuts and front exhaust pipe assembly.

  1. Remove the 3 gaskets from the front exhaust pipe assembly.



6. REMOVE AIR FUEL RATIO SENSOR (for Bank 1)


    A255480
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the harness clamp.



    A255015E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

    SST
    09224-00011  



7. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH


    A255521
  1. Using a 12 mm deep socket wrench, remove the 6 nuts and exhaust manifold sub-assembly RH.



    A255352
  1. Remove the gasket from the cylinder head sub-assembly.



8. REMOVE AIR FUEL RATIO SENSOR (for Bank 2)


    A255011
  1. Disconnect the air fuel ratio sensor connector.



    A255012
  1. Separate the wire harness clamp.



    A255013E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.

    SST
    09224-00011  



9. REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE


    A202567
  1. Remove the oil level dipstick.

  1. Remove the bolt and No. 2 engine oil level dipstick guide.



    A254364
  1. Remove the O-ring from the No. 2 engine oil level dipstick guide.



10. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A197636
  1. Remove the 3 bolts and No. 2 exhaust manifold heat insulator.



11. REMOVE NO. 2 MANIFOLD STAY


    A140783
  1. Remove the bolt, nut and No. 2 manifold stay.



12. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    A197637
  1. Using a 12 mm deep socket wrench, remove the 6 nuts and exhaust manifold sub-assembly LH.



    A255353
  1. Remove the gasket from the cylinder head sub-assembly.