Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)

AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Mute Signal Circuit between Radio Receiver and Telematics Transceiver

for Preparation Click here


DESCRIPTION

The telematics transceiver sends a mute signal to the radio receiver assembly.
The radio receiver assembly controls the volume according to the mute signal from the telematics transceiver.

WIRING DIAGRAM


E262317E97


INSPECTION PROCEDURE

NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be necessary. Refer to Precaution for Audio and Visual System. (Click here).

1.INSPECT TELEMATICS TRANSCEIVER


    E259127E47
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I218-17 (MUTE) - Body ground
    Engine switch on (ACC)
    Audio system playing
    → Emergency call mode
    2.0 V or higher
    → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Telematics Transceiver)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - TELEMATICS TRANSCEIVER)
  1. Disconnect the I148 radio receiver assembly connector.

  1. Disconnect the I218 telematics transceiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I148-8 (TMUT) - I218-17 (MUTE)
    Always
    Below 1 Ω
    I148-8 (TMUT) or I218-17 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT RADIO RECEIVER ASSEMBLY
  1. Disconnect the I218 telematics transceiver connector.



    E176650E46
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I218-17 (MUTE) - Body ground
    Engine switch on (ACC)
    2.0 V or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Telematics Transceiver)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK

REPLACE TELEMATICS TRANSCEIVER (Click here)