Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System)

DTC    B279C    Theft Deterrent System Presence Detection

for Preparation Click here


DESCRIPTION

If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.

DTC No.
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C
An ECM that is incompatible with engine immobiliser system is installed.
ECM
Check for DTCs.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
-

Related Data List and Active Test 
DTC No.
Data List and Active Test
B279C
-

INSPECTION PROCEDURE

NOTICE:
  1. If the ECM is replaced, refer to Service Bulletin.
  2. After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

1.REPLACE ECM
  1. Temporarily replace the ECM with a new one (Click here).


NEXT


2.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID.

    HINT:
    Refer to Service Bulletin.


NEXT


3.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


4.CHECK FOR DTC
  1. Perform "DTC Output Confirmation Operation" procedure.

  1. Check for DTCs (Click here).

    OK:
    DTC B279C is not output.

Result:
Result
Proceed to
DTC B279C is not output
A
DTC B279C is output
B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

END (ECM WAS DEFECTIVE)