Home › Vehicle Interior › LIGHTING (INT) › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > REMOVAL

for Preparation Click here



1. REMOVE LOWER STEERING COLUMN COVER

NOTICE:
Removing the lower steering column cover in the incorrect order will cause the parts to break.

  1. Release the tilt and telescopic lever, and fully extend and lower the steering column assembly.

  1. Lock the tilt and telescopic lever.



    E228107
  1. Turn the steering wheel assembly to the left and remove the screw.



    E228108
  1. Turn the steering wheel assembly to the right and remove the screw.



    E228109
  1. Push the right and left sides of the lower steering column cover to disengage the 2 claws.



    E228110
  1. Insert your fingers into the opening of the tilt lever of the lower steering column cover to disengage the 2 claws.

    HINT:
    Spread the claws to disengage them.



2. REMOVE TRANSPONDER KEY COIL


    B371708
  1. Disengage the 2 claws and disconnect the transponder key coil.



    B371710
  1. Disconnect the connector to remove the transponder key coil.