Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE

FRONT BRAKE FLEXIBLE HOSE > REMOVAL

for Preparation Click here


NOTICE:
If the left and right hoses are disconnected at the same time, be sure to place a mark on each hose to indicate its installation position.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, immediately wash it off.



3. REMOVE FRONT FLEXIBLE HOSE


    C238481
  1. Remove the union bolt and gasket, and separate the front flexible hose from the front disc brake cylinder assembly.



    C238495E01
  1. Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.
    Text in Illustration 
    *1
    Clip

    NOTICE:
    1. Do not kink or damage the brake line.
    2. Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

  1. Remove the clip.



    C238496
  1. Remove the bolt and front flexible hose from the front shock absorber assembly.