BRAKE PEDAL (for RHD) > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT |
| 2. REMOVE STOP LIGHT SWITCH ASSEMBLY |
![]() |
Disconnect the connector.
![]() |
Turn the stop light switch assembly counterclockwise and remove it.
| 3. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER |
| 4. REMOVE PUSH ROD PIN |
![]() |
Remove the clip and push rod pin.
Separate the brake master cylinder push rod clevis from the brake pedal support assembly.
| 5. REMOVE BRAKE PEDAL RETURN SPRING |
![]() |
Remove the brake pedal return spring from the brake pedal support assembly.
| 6. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY |
![]() |
Disconnect the brake pedal load sensing switch connector.
![]() |
Disengage the 3 clamps and separate the wire harness from the brake pedal support assembly.
![]() |
Remove the 4 nuts and brake pedal support assembly.