BRAKE BOOSTER (for LHD) > REMOVAL |
| 1. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
| 2. DISCONNECT ENGINE WIRE (for 6AR-FSE) |
![]() |
Disconnect the engine wire connector from the vacuum warning switch assembly.
| 3. SEPARATE NO. 1 HOSE TO HOSE TUBE (for 2AR-FE) |
![]() |
Slide the clip and disconnect the No. 1 hose to hose tube from the brake booster assembly.
Remove the 2 nuts to separate the No. 1 hose to hose tube from the vehicle body.
| 4. REMOVE UNION TO CHECK VALVE HOSE (for 6AR-FSE) |
![]() |
Slide the clip and disconnect the union to check valve hose from the brake booster assembly.
| 5. DISCONNECT UNION TO CHECK VALVE HOSE (for 2GR-FE) |
![]() |
Slide the clip and disconnect the union to check valve hose from the brake booster assembly.
| 6. REMOVE PUSH ROD PIN |
![]() |
Remove the clip and push rod pin.
Separate the brake master cylinder push rod clevis from the brake pedal support assembly.
| 7. REMOVE BRAKE BOOSTER ASSEMBLY |
![]() |
Remove the 4 nuts and brake booster assembly from the vehicle body.
| 8. REMOVE BRAKE BOOSTER GASKET |
![]() |
Remove the brake booster gasket from the brake booster assembly.
| 9. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS |
Loosen the lock nut and remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.
| 10. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY |
Remove the brake vacuum check valve assembly from the brake booster assembly.
Remove the check valve grommet from the brake booster assembly.
| 11. REMOVE VACUUM WARNING SWITCH ASSEMBLY (for 6AR-FSE) |
Remove the vacuum warning switch assembly from the brake booster assembly.
Remove the check valve grommet from the brake booster assembly.