DTC B2785 Communication Malfunction between ECUs Connected by LIN |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2785 |
|
|

| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - EACH ECU) |
Disconnect the I78 certification ECU (smart key ECU assembly) connector.
Disconnect the I24 steering lock ECU (steering lock actuator assembly) connector.
Disconnect the I20 ID code box (immobiliser code ECU) connector*.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-17 (LIN) - I24-5 (LIN) | Always | Below 1 Ω |
| I78-17 (LIN) - I20-2 (LIN1)* | Always | Below 1 Ω |
| I78-17 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT (STEERING LOCK ECU) |
Reconnect the I78 certification ECU (smart key ECU assembly) connector.
Reconnect the I20 ID code box (immobiliser code ECU) connector*.
Clear the DTC (Click here).
Recheck for DTCs.
*: w/ Entry Function on Driver Door except TMMK Made
| Result | Proceed to |
| DTC B2785 is output (w/ Entry Function on Driver Door except TMMK Made) | A |
| DTC B2785 is output (w/o Entry Function on Driver Door or for TMMK Made) | B |
| DTC B2785 is not output | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK DTC OUTPUT (ID CODE BOX (IMMOBILISER CODE ECU)) |
Reconnect the I24 steering lock ECU (steering lock actuator assembly) connector.
Disconnect the I20 ID code box (immobiliser code ECU) connector.
Clear the DTC (Click here).
Recheck for DTCs.
| Result | Proceed to |
| DTC B2785 is output | A |
| DTC B2785 is not output | B |
|
| ||||
| A | ||
| ||