Home › Vehicle Interior › SEAT › FRONT SEATBACK HEATER (for TMC, TMMR Made Power Seat)

FRONT SEATBACK HEATER (for TMC, TMMR Made Power Seat) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER


    B281093
  1. Disconnect the rubber band of the separate type front seatback cover.



3. DISCONNECT CONNECTOR


    B281106
  1. Disconnect the connector.

  1. Disengage the clamp.



4. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD


    B281110
  1. Remove the 5 hog rings.



    B281113
  1. Remove the 3 hog rings.



    B280127
  1. Remove the 2 hog rings.

  1. Turn back the separate type front seatback cover.



    B281115
  1. Remove the nut and the 2 brackets.



    B281072
  1. Disengage the 4 claws and remove the 2 front seat headrest supports.

  1. Remove the separate type front seatback cover with pad.



5. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B281073
  1. Remove the 6 hog rings and separate type front seatback cover from the separate type front seatback pad.