Component
| Function
|
Outer rear view mirror assembly
| Vertical mirror motor
| Receives a signal from the outer mirror control ECU assembly and adjusts the mirror surface position vertically.
|
Horizontal mirror motor
| Receives a signal from the outer mirror control ECU assembly and adjusts the mirror surface position horizontally.
|
Power retract mirror motor
| Receives a signal from the outer mirror control ECU assembly, and retracts and returns the outer rear view mirror assemblies.
|
Mirror position sensor
| Detects the mirror surface position. This data is detected by the outer mirror control ECU assembly.
|
Mirror heater
| Receives a signal from the outer mirror control ECU assembly and operates the mirror heater.
|
Outer mirror switch assembly
| Mirror select switch
| Consists of R and L switches. One must be chosen to operate the outer mirror switch assembly.
|
Mirror adjust switch
| Mirror R and L signals are sent to each outer mirror control ECU assembly from the mirror select switch. After selecting the R or L switch, the right, left, up and down control switches can be operated to change the angle of the mirror.
|
Retractable outer mirror switch
| Retracts and returns the outer rear view mirror assemblies. Mirror retract and return signals are sent to each outer mirror control ECU assembly from the main body ECU (multiplex network body ECU).
|
Seat memory switch
| When the seat memory M1 or M2 switch is pressed while the SET switch is being pressed, or the M1 or M2 switch is pressed within 3 seconds of the SET switch being pressed, a signal is sent to the outer mirror control ECU assembly (driver door), which records the mirror surface position. When the seat memory switch is pressed, a signal is sent to the outer mirror control ECU assembly (driver door) and sent to the main body ECU (multiplex network body ECU), which changes the mirror surface position to the memorized position.
|
Outer mirror control ECU assembly
| Operates each mirror motor based on signals from the mirror select switch and mirror adjust switch. Based on information from the mirror position sensors, 2 different mirror surface positions can be stored. By operating a seat memory switch, the mirror surface moves to the stored position.
|