Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR

RAIN SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT RAIN SENSOR


    E169141E14
  1. Disconnect the S1 rain sensor connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    S1-4 (SIG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S1-2 (ES) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rain Sensor)
    If the result is not as specified, repair or replace the harness or connector.



    E141656E36
  1. Reconnect the rain sensor connector.

  1. Connect an oscilloscope to the rain sensor connector.

  1. Check for pulses.

    OK:
    Tester Connection
    Condition
    Specified Condition
    1 (MPX) - 2 (ES)
    Ignition switch ON
    Pulse generation

    Text in Illustration 
    *a
    Component with harness connected
    (Rain Sensor)
    If the result is not as specified, the rain sensor may have a malfunction.