Home › Engine / Hybrid System ยท 2GR-FE › ENGINE CONTROL › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repairs" after replacing the spark plug and ignition coil assembly (Click here).



1. INSTALL SPARK PLUG


    A191153
  1. Install the 6 spark plugs.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    HINT:
    Perform "Inspection After Repairs" after replacing the spark plug (Click here).



2. INSTALL IGNITION COIL ASSEMBLY
  1. Install the 6 ignition coils with the 6 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    HINT:
    Perform "Inspection After Repairs" after replacing the ignition coil assembly (Click here).

  1. Connect the 6 ignition coil connectors.

  1. Connect the 2 wire harness clamps.

  1. Install the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



3. INSTALL NO. 1 SURGE TANK STAY

NOTICE:
Do not apply oil to the bolt as listed below:
Oil Application Prohibited Bolt
Bolt for No. 1 surge tank stay and cylinder head cover

  1. Install the No. 1 surge tank stay with the bolt.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



4. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
(Click here).