OIL PRESSURE SWITCH > INSTALLATION |
| 1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY |
![]() |
Apply adhesive to 2 or 3 threads of the oil pressure switch.
| *1 | Adhesive |
Using a deep socket wrench, install the oil pressure switch.
Connect the connector.
| 2. INSPECT FOR OIL LEAK |
| 3. INSPECT ENGINE OIL LEVEL |
Warm up the engine, stop it and wait 5 minutes. The oil level should be between the engine oil level dipstick low level mark and full level mark.
If the engine oil level is low, check for leakage and add oil up to the full level mark.