Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH

UNLOCK WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY


B203483E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch free (Key removed)
    10 kΩ or higher
    1 - 2
    Switch pushed (Key set)
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Unlock Warning Switch Assembly)
    If the result is not as specified, replace the unlock warning switch assembly.