Home › Engine / Hybrid System ยท 2AR-FE › FUEL › FUEL SENDER GAUGE ASSEMBLY (for TMMK Made)

FUEL SENDER GAUGE ASSEMBLY (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A283914E01
  1. Slide the fuel sender gauge assembly downward and engage the claw (A) to install the fuel sender gauge assembly.

  1. Connect the fuel sender gauge assembly connector.

  1. Install the 2 wire harness protectors to the wire harness.

    NOTICE:
    Do not damage the wire harness.

  1. Engage the 2 wire harness clamps.

    NOTICE:
    Do not damage the wire harness.



2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)