Home › Engine / Hybrid System · 2AR-FE › FUEL › FUEL SENDER GAUGE ASSEMBLY (for TMMK Made)

FUEL SENDER GAUGE ASSEMBLY (for TMMK Made) > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    A347571E01
  1. Check that the float moves smoothly between F and E.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sender Gauge Assembly)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Float Level
    Specified Condition
    1 - 2
    F
    13.5 to 16.5 Ω
    Between F and E
    13.5 to 414.5 Ω
    (Gradually changes)
    E
    405.5 to 414.5 Ω

    If the result is not as specified, replace the fuel sender gauge assembly.