Home › Engine / Hybrid System ยท 2AR-FE › FUEL › FUEL SENDER GAUGE ASSEMBLY (for TMMK Made)

FUEL SENDER GAUGE ASSEMBLY (for TMMK Made) > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)


2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A283909E02
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the wire harness clamp as shown in the illustration.
    Text in Illustration 
    *a
    Tube
    *b
    Protective Tape

    NOTICE:
    Do not damage the tube and wire harness.

  1. Disengage the wire harness clamp.

    NOTICE:
    Do not damage the wire harness.



    A283910
  1. Remove the 2 wire harness protectors from the wire harness.

    NOTICE:
    Do not damage the wire harness.



    A283911
  1. Disconnect the fuel sender gauge assembly connector.



    A283912E01
  1. Push the claw (A) of the fuel sender gauge assembly, and then pull up the fuel sender gauge assembly to remove it.

    NOTICE:
    1. Do not touch the resistance plate or contacts of the fuel sender gauge assembly.
    2. Be careful not to bend the arm of the fuel sender gauge assembly.