Home › Steering › STEERING COLUMN › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Engage the 2 claws, 2 pins and 2 guides to install the steering pad switch assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. w/ Shift Paddle Switch Wire of Steering Pad Switch Assembly:

    1. Engage the clamp.

  1. Connect the steering pad switch connector to the spiral cable sub-assembly.



    C279318
  1. Pass the wire harness over the 2 guides.



2. INSTALL HORN BUTTON ASSEMBLY
  1. for TMMK Made: (Click here)
  2. for TMC, TMMR Made: (Click here)