Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH (for TMMK Made)

VSC OFF SWITCH (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL VSC OFF SWITCH
  1. Engage the 2 claws to install the VSC OFF switch to the instrument cluster finish panel assembly.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B377612
  1. Temporarily install the instrument cluster finish panel assembly as shown in the illustration.

  1. Connect each connector.

  1. Engage the 5 claws, 5 clips and 2 guides, and install the instrument cluster finish panel assembly.



    B399736
  1. Engage the 2 claws, 4 clips and 2 guides.



3. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B377607
  1. Engage the 4 clips to install the No. 1 instrument panel register assembly.



4. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B399737
  1. Engage the 3 clips to install the No. 1 instrument cluster finish panel garnish as shown in the illustration.



5. INSTALL INSTRUMENT SIDE PANEL LH
  1. Engage the 3 guides.



    B377600
  1. Engage the 4 claws to install the instrument side panel LH as shown in the illustration.



6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B278980E02
  1. Align the alignment mark (Yellow) on the weatherstrip with the protruding portion on the vehicle body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
    Text in Illustration 
    *a
    Alignment Mark (Yellow)

    NOTICE:
    After installation, check that the corners fit correctly.