VSC OFF SWITCH (for TMC, TMMR Made) > REMOVAL |
| 1. REMOVE NO. 1 SWITCH HOLE BASE |
![]() |
Apply protective tape to the areas shown in the illustration.
| *1 | Protective Tape |
Using a moulding remover, disengage the 4 claws and 2 guides as shown in the illustration.
Disconnect the connector and remove the No. 1 switch hole base.
| 2. REMOVE VEHICLE STABILITY CONTROL SWITCH (for LHD) |
![]() |
Disengage the 2 claws to remove the vehicle stability control switch.
| 3. REMOVE VEHICLE STABILITY CONTROL SWITCH (for RHD) |
![]() |
Disengage the 2 claws to remove the vehicle stability control switch.