Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH (for TMMK Made)

VSC OFF SWITCH (for TMMK Made) > REMOVAL

for Preparation Click here



1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B399740
  1. Disconnect the front door opening trim weatherstrip LH.



2. REMOVE INSTRUMENT SIDE PANEL LH


    B377599
  1. Using a moulding remover, disengage the 4 claws as shown in the illustration.



    B399733
  1. Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.



3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B399734
  1. Disengage the 3 clips to remove the No. 1 instrument cluster finish panel garnish as shown in the illustration.



4. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B377605
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    V100155
    Protective Tape



    B377606
  1. Disengage the 2 clips as shown in the illustration.



    B377608
  1. Using a moulding remover, disengage the 2 clips to remove the No. 1 instrument panel register assembly.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.



    B399735
  1. Using a moulding remover, disengage the 2 claws, 4 clips and 2 guides.



    B377610
  1. Disengage the 5 claws, 5 clips and 2 guides.

  1. Disconnect each connector.



    B377611
  1. Remove the instrument cluster finish panel assembly as shown in the illustration.



6. REMOVE VSC OFF SWITCH


    C238439
  1. Disengage the 2 claws and remove the VSC OFF switch from the instrument cluster finish panel assembly.