Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH (for TMC, TMMR Made)

VSC OFF SWITCH (for TMC, TMMR Made) > INSPECTION

for Preparation Click here



1. INSPECT VEHICLE STABILITY CONTROL SWITCH


    C311100E02
  1. Make sure that there is no looseness in the locking part and the connecting part of the connector.

  1. Disconnect the VSC OFF switch (vehicle stability control switch) connector.

  1. Check both the connector case and the terminal for deformation and corrosion.

    OK:
    No deformation or corrosion.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (+) - 6 (E)
    Switch pushed
    Below 1 Ω
    9 (+) - 6 (E)
    Switch not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (VSC OFF Switch (Vehicle Stability Control Switch))
    If the result is not as specified, replace the VSC OFF switch (vehicle stability control switch).