FRONT BUMPER (for TMC, TMMR Made) > INSTALLATION |
| 1. INSTALL FRONT BUMPER ASSEMBLY |
w/ Headlight Cleaner System:
Connect the headlight cleaner hose.
Move the front bumper assembly into position and install the 2 clips.
Install the bolt and 2 screws.
Pull back the side of the front bumper assembly and connect each connector.
![]() |
Engage the 3 claws.
![]() |
Install the pin hold clip as shown in the illustration.
| *1 | Pin Hold Clip |
| *a | Correct |
| *b | Incorrect |
Install the clip.
Install the front bumper assembly with the 8 screws.
| 2. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 9 clips.
| 3. ADD WASHER FLUID (w/ Headlight Cleaner System) |
Add washer fluid to the washer jar.
| 4. ADJUST FOG LIGHT ASSEMBLY |