FRONT BUMPER (for TMMK Made) > INSTALLATION |
| 1. INSTALL FRONT BUMPER ASSEMBLY |
![]() |
Move the front bumper assembly into position as shown in the illustration.
Pull back the side of the front bumper assembly and connect the 2 daytime running light connectors.
Install the 2 bolts.
Install the 2 hood center cushions and clip.
![]() |
Engage the 3 claws to install the front bumper assembly as shown in the illustration.
![]() |
Install the pin hold clip as shown in the illustration.
| *1 | Pin Hold Clip |
| *a | Correct |
| *b | Incorrect |
Install the clip.
Install the 7 screws.
| 2. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 9 clips.