Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (for TMC, TMMR Made)

FRONT BUMPER (for TMC, TMMR Made) > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL


    B382622
  1. Remove the 9 clips and cool air intake duct seal.



2. REMOVE FRONT BUMPER ASSEMBLY


    B382623
  1. Apply protective tape around the front bumper assembly as shown in the illustration.
    Text in Illustration 
    V100155
    Protective Tape



    B382625
  1. Remove the 8 screws.



    B382624E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
    Text in Illustration 
    *1
    Pin Hold Clip
    *a
    90°

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B382626
  1. Disengage the 3 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Pull back the side of the front bumper assembly and disconnect each connector.

    NOTICE:
    Do not apply excessive force when pulling back the front bumper assembly.



    B382628
  1. Remove the bolt and 2 screws.

  1. Remove the 2 clips.



  1. w/ Headlight Cleaner System:



      B282867
    1. Disconnect the headlight cleaner hose and drain the washer fluid.

      HINT:
      Use a container to collect the washer fluid.

  1. Remove the front bumper assembly.