Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (for TMMK Made)

FRONT BUMPER (for TMMK Made) > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL


    B400895
  1. Remove the 9 clips and cool air intake duct seal.



2. REMOVE FRONT BUMPER ASSEMBLY


    B400896
  1. Apply protective tape around the front bumper assembly as shown in the illustration.
    Text in Illustration 
    V100155
    Protective Tape



    B381229
  1. Remove the 7 screws.



    B381224E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
    Text in Illustration 
    *1
    Pin Hold Clip
    *a
    90°

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B400897E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws as shown in the illustration.
    Text in Illustration 
    *a
    Screwdriver
    V100155
    Protective Tape

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Pull back the side of the front bumper assembly and disconnect the 2 daytime running light connectors.

    NOTICE:
    Do not apply excessive force when separating the front bumper assembly.



    B400905
  1. Using a clip remover, remove the clip and 2 hood center cushions.



    B400906
  1. Remove the 2 bolts.



    B400907
  1. Remove the front bumper assembly as shown in the illustration.