Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER (for TMMK Made)

REAR BUMPER (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL REAR BUMPER ASSEMBLY


    B400922
  1. Engage the 6 claws as shown in the illustration.



    B400923
  1. Engage the 7 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the screw.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the 4 clips.

  1. Install the 7 screws.

  1. Install the rear bumper assembly with the 2 screws.



2. INSTALL REAR BUMPER PLATE LH


    B381245E01
  1. Engage the hook.
    Text in Illustration 
    *a
    Hook

  1. Engage the 2 claws to install the rear bumper plate LH.



3. INSTALL REAR BUMPER PLATE RH

HINT:
Use the same procedure as for the LH side.